Direct answer: 10 in × 30 in hole
Concrete bag formula
Concrete volume is a cylinder: π × radius² × depth. Convert the hole diameter and fill depth to feet, multiply by the number of holes, add an overage allowance, then divide by the yield of one bag. The result is rounded up because you cannot buy a fraction of a bag.
The formula assumes a cylindrical hole. Auger holes can be bell-shaped or irregular, which is why the conservative option does not subtract the post volume.
Concrete bag yield table
| Hole (diameter × fill) | Volume | 50 lb bags | 60 lb bags | 80 lb bags |
|---|---|---|---|---|
| 8 in × 24 in | 0.70 ft³ | 1.9 | 1.6 | 1.2 |
| 10 in × 30 in | 1.36 ft³ | 3.6 | 3.0 | 2.3 |
| 12 in × 36 in | 2.36 ft³ | 6.3 | 5.2 | 3.9 |
These are nominal bag counts before a project-level overage. Add 5–10% for spillage, irregular holes, and uneven ground. Always check the yield printed on the bag; different mixes and brands can vary.
Gravel base and fill depth
A 4–6 in gravel base at the bottom of the hole helps drain water away from the post. If you include gravel, the concrete fill depth is shorter than the total hole depth. For example, a 30 in hole with 6 in of gravel has a 24 in concrete fill. Enter 24 in in the calculator, not 30 in, or you will over-order concrete.
Slope the top of the concrete slightly away from the post so water runs off. Do not fill the hole above grade unless local practice calls for a raised collar. Call 811 before digging and check local frost-depth requirements.
Post displacement: 4×4, 6×6, and steel
A buried post takes up space that would otherwise be concrete. A 4×4 post (3.5 in actual) displaces about 0.21 ft³ in a 30 in hole; a 6×6 post (5.5 in actual) displaces about 0.52 ft³. Subtracting displacement gives a tighter estimate, but a bell-shaped auger hole can hold more concrete than the cylinder formula suggests.
For a first order, use the conservative no-subtraction estimate and keep one or two extra bags. For a large fence, run both numbers and compare the difference before choosing.
Frequently Asked Questions
How many 80 lb bags of concrete per fence post?
A 10 in diameter hole with a 30 in concrete fill holds about 1.36 ft³. At 0.60 ft³ per 80 lb bag, that is 2.27 bags per post. For 14 posts with a 10% overage, buy 35 bags. Round up to whole bags and check the yield printed on your product.
Should I use 50 lb or 80 lb bags?
An 80 lb bag yields about 0.60 ft³; a 50 lb bag yields about 0.375 ft³. The 80 lb bag needs fewer bags and fewer mixes, but it is heavier to carry. For the same 10 in × 30 in hole, you need about 2.27 bags of 80 lb or 3.64 bags of 50 lb before overage.
How much concrete for a 4×4 post?
For a 10 in × 30 in hole, plan on about 2.27 bags of 80 lb concrete. If you subtract the buried 3.5 in × 3.5 in post, remove about 0.21 ft³ per hole, or roughly 15% of the concrete. The safest approach is to use the conservative no-subtraction number and round up.
Do I need gravel under the post?
A 4–6 in crushed-gravel base is common for drainage. The calculator does not include gravel in the concrete volume. If you dig a 30 in hole and add 6 in of gravel, enter 24 in as the concrete fill depth.
How deep should the concrete footing be?
A common rule is to bury one-third of the post length, then extend below the local frost line in cold climates. Frost depth, soil, wind exposure, and permits are local. Verify with your building department and call 811 before digging.
Can I use ready-mix concrete instead of bags?
For 14 holes at 10 in × 30 in, the total is about 21 ft³ or 0.78 yd³ with 10% overage. Ready-mix suppliers often have minimum loads and delivery fees, so bags are usually more practical for a small fence. For a large fence, compare the delivered cost.