GUIDE 01 / PERIMETER SURVEY5 MIN READ

How to Measure a Fence Line Accurately

Direct rule

Measure every straight run separately from corner to corner. Subtract gate clear openings from the picket run. Add two dedicated gate posts per gate and one terminal post per 90° corner.

HOUSE STRUCTURE (NO FENCE)4' GATE OPENINGBACK RUN: 60 FT (CORNER TO CORNER)LEFT: 35 FTRIGHT: 35 FT
  1. Confirm property pins and call 811. Build 2–4 in inside your property line. Call 811 at least 48 hours before digging so buried power, gas, and fiber lines are marked.
  2. Measure straight segments separately. Do not pull one tape around corners. Break the yard into left return, left side, back line, right side, and right return.
  3. Subtract gate openings. A 4 ft gate removes 4 ft from the picket run and needs two gate posts. Do not count the gate leaf as fence length.
  4. Handle slopes deliberately. On slopes steeper than about 1 ft of drop over 8 ft, choose stepped bays or racked rails. Racked fences may need longer pickets so the bottom can be trimmed parallel to the ground.
  5. Write down the segments. Enter each straight run into the calculator separately or add the runs and keep corners/gates in the notes. The calculator's gate model assumes gates divide the fence into equal sections.

Turning measurements into a material order

Total length alone is not enough for an accurate takeoff. Gate openings change the effective picket run and add posts, and every 90° corner adds a terminal post. Enter the straight lengths, gate count, gate width, and corner count into thewood fence calculator; the result is the same whether you measure in feet or meters because the engine converts units at the input boundary.

Round the order up and keep a waste allowance for defects and miscuts. For a single straight run the default 10% is usually enough; for cut-up yards with several short returns, use 15%.

Connected tools & field guides